#NEC SPECTRAVIEW MONITORS SOFTWARE#

You can select your saved settings from a drop-down list and it will reload the LUT into the monitor.

#NEC SPECTRAVIEW MONITORS SOFTWARE#

The SpectraView software also allows you to save your calibrations and recall them. With these I find the CalMAN calibration to perform better. It also might just be that the method the software uses is not as effective at lower light targets. This might be due to using the i1Pro and it not performing as well in lower-light situations. When I re-ran the NEC Calibration and targeted 80 cd/m^2 instead of 200, the results are not nearly as good. No individual measurements rise over a dE2000 of 2.0, and that means you should have no visible errors now. You can save multiple different targets in the SpectraView software and then load them back up later if you need to work in multiple environments.ДЄverage saturation and color checker dE2000 errors are below 0.9, which is incredibly impressive. The calibration is also much quicker than CalMAN, which is nice. Once connected you choose your targets (D65 white point, 2.2 gamma, 200 cd/m^2, and sRGB gamut here) and then the software calibrates the PA242W.

The C6 is accurate if you profile it, but the NEC software does not allow for this. It isnвЂ™t as good at low-light as the C6, but it's more color accurate. You can use a wide variety of meters with SpectraView but I chose to use my i1Pro. Using SpectraView, NEC will reset your video-card LUT to be neutral and rely only on the monitor LUT so it will work correctly afterwards on almost any PC. The NEC PA242W contains a 14-bit, 3D LUT that allows you to correct the output to be almost perfect. Most software packages like CalMAN work with the video card LUTs to improve calibration, and the monitor LUTs if they can access them. NEC offers their own calibration software, SpectraView, for their monitors.

Nec spectraview monitors